Epitalon is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-04-18. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
The proposed relationship between epitalon and pineal function is a central part of its background. Khavinson's group reported that short peptides corresponding to regions of larger pineal proteins could influence gene expression in cells. Epitalon was framed as a synthetic analogue of an active fragment rather than a direct isolation product. Whether the tetrapeptide reproduces the effects of the parent extract is an open question, because comparative studies are limited and the parent extract itself is not a single defined substance.
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
LSD is a chiral compound with two stereocenters at the carbon atoms C-5 and C-8, so that theoretically four different optical isomers of LSD could exist. LSD, also called d-LSD or (+)-LSD, has the absolute configuration (5R,8R). The other stereoisomers are iso-LSD (d-iso-LSD), l-LSD, and l-iso-LSD. The 5S- or levo- stereoisomers of lysergamides do not exist in nature and are not formed during the synthesis from d-lysergic acid. Retrosynthetically, the C-5 stereocenter could be analysed as having the same configuration as the alpha carbon of the naturally occurring amino acid L-tryptophan, the precursor to all biosynthetic ergoline compounds. However, LSD and iso-LSD, the two C-8 isomers, rapidly interconvert in the presence of bases, as the alpha proton is acidic and can be deprotonated and reprotonated. Non-psychoactive iso-LSD, which has formed during the synthesis, can be separated by chromatography and can be isomerized to LSD. Pure salts of LSD are triboluminescent, emitting small flashes of white light when shaken in the dark. LSD is strongly fluorescent and will glow bluish-white under UV light.
For elements that have one naturally occurring isotope (mononuclidic elements) or one dominant isotope, the difference between the atomic mass of the most common isotope, and the (standard) relative atomic mass or (standard) atomic weight will be nil, or small enough to not effect most calculations. For elements with more than one isotope in significant quantities, the mass of individual atoms will be different from an average across all the isotopes. For elements that have more than one common isotope, the numerical difference in relative atomic mass (atomic weight) from even the most common relative isotopic mass, can be half a mass unit or more (e.g. see the case of chlorine where atomic weight and standard atomic weight are about 35.45). The atomic mass (relative isotopic mass) of an uncommon isotope can differ from the relative atomic mass, atomic weight, or standard atomic weight, by several mass units. Relative isotopic masses are always close to whole-number values, but never (except in the case of carbon-12) exactly a whole number, for two reasons:
== Pharmacokinetics == The full pharmacokinetic properties of phenazopyridine have not been determined. It has mostly been studied in animal models, but they may not be very representative of humans. Rat models have shown its half-life to be 7.35 hours, and 40% is metabolized hepatically (by the liver).
Sources: en.wikipedia.org
The first suborbital spacecraft weighed 3,000 pounds (1,400 kg); the heaviest, Mercury-Atlas 9, weighed 3,000 pounds (1,400 kg) fully loaded. On reentry, the astronaut would stay in the craft through splashdown by parachute in the Atlantic Ocean.
Most Pakistanis, according to a Pew Research Center (PEW) poll, favour Sharia law as the official law, and 94 percent of them identify more with religion than nationality compared to Muslims in other nations.
Benzodiazepines such as flunitrazepam are lipophilic and rapidly penetrate membranes and, therefore, rapidly cross over into the placenta with significant uptake of the drug. Use of benzodiazepines including flunitrazepam in late pregnancy, especially high doses, may result in hypotonia, also known as floppy baby syndrome.
Sources: en.wikipedia.org
=== Blocked catheters === Alteplase can be used in small doses to clear blood clots that obstruct a catheter, reopening the catheter so it can continue to be used. Catheter obstruction is commonly observed with a central venous catheter. Currently, the standard treatment for catheter obstructions in the United States is alteplase administration. Alteplase is effective and low risk for treating blocked catheters in adults and children. Overall, adverse effects of alteplase for clearing blood clots are rare. Novel alternatives to treat catheter occlusion, such as tenecteplase, reteplase, and recombinant urokinase, offer the advantage of shorter dwell times than alteplase.
== Chemical properties == It reacts with cesium fluorosulfonate and silver fluorosulfonate to produce the divalent silver compound CsAg(SO3F)3. Iodine(I) fluorosulfonate can be obtained from iodine and peroxydisulfuryl difluoride:
The bodies of vascular plants including clubmosses, ferns and seed plants (gymnosperms and angiosperms) generally have aerial and subterranean subsystems. The shoots consist of stems bearing green photosynthesising leaves and reproductive structures. The underground vascularised roots bear root hairs at their tips and generally lack chlorophyll. Non-vascular plants, the liverworts, hornworts and mosses do not produce ground-penetrating vascular roots and most of the plant participates in photosynthesis. The sporophyte generation is nonphotosynthetic in liverworts but may be able to contribute part of its energy needs by photosynthesis in mosses and hornworts. The root system and the shoot system are interdependent – the usually nonphotosynthetic root system depends on the shoot system for food, and the usually photosynthetic shoot system depends on water and minerals from the root system. Cells in each system are capable of creating cells of the other and producing adventitious shoots or roots. Stolons and tubers are examples of shoots that can grow roots. Roots that spread out close to the surface, such as those of willows, can produce shoots and ultimately new plants. In the event that one of the systems is lost, the other can often regrow it. In fact it is possible to grow an entire plant from a single leaf, as is the case with plants in Streptocarpus sect. Saintpaulia, or even a single cell – which can dedifferentiate into a callus (a mass of unspecialised cells) that can grow into a new plant.
== Stimulus == How the secretion of motilin is regulated is largely unknown, although some studies suggest that an alkaline pH in the duodenum stimulates its release. However, at low pH it inhibits gastric motor activity, whereas at high pH it has a stimulatory effect. Some studies in dogs have shown that motilin is released during fasting or interdigestive period, and intake of food during this period can prevent the secretion of motilin. Intravenous injection of glucose, which increases the release of insulin, is also found to inhibit cyclic elevation of plasma motilin. Other studies on dogs have also suggested that motilin acted as endogenous ligand in positive feedback mechanism to stimulate the release of more motilin. In dogs and cats, motilin secretion is stimulated by hydrogen ions (protons) and lipids when the animal is in a "fed" state. However, during fasting, motilin is periodically released into the serum to initiate phase III of the migrating motor complex.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.