Everything below concerns epitalon. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2025-10-22. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is a synthetic tetrapeptide whose sequence is alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. It was developed in Russia during the 1980s and 1990s by investigators associated with the St. Petersburg Institute of Bioregulation and Gerontology, who studied short peptides as regulators of gene expression and tissue function. The alternative spelling epithalon appears interchangeably in the literature, and the two names refer to the same molecule. Outside Russia it is encountered chiefly as a research chemical rather than a licensed medicine, and it holds no approval from the United States Food and Drug Administration or the European Medicines Agency.
The peptide is a synthetic analogue of epithalamin, a preparation extracted from bovine pineal glands. Investigators sought a short, chemically defined molecule that would reproduce some of the endocrine and gerontological observations attributed to the glandular extract. Proposed mechanisms centre on induction of telomerase activity, an effect reported in cultured human somatic cells in the early 2000s, together with influences on melatonin secretion and neuroendocrine regulation. Those mechanisms remain incompletely characterised, and the reported telomerase response has not been consistently reproduced by independent groups working in comparable systems.
Published work on this compound consists mainly of in vitro experiments, animal studies, and small clinical investigations, a substantial share of which appeared in Russian-language journals. Sample sizes are generally small, control conditions differ between studies, and several endpoints rely on markers whose clinical meaning is itself debated. Reviews of the longevity field treat the peptide as an early example of telomerase-directed research rather than an established intervention. Regulatory treatment varies by country: some jurisdictions place it under prescription controls, others treat it as a laboratory material, and importation may be restricted regardless of local status.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Epitalon is a synthetic tetrapeptide with the residue sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its monoisotopic mass is approximately 390.35 daltons, and it is usually supplied as a lyophilised trifluoroacetate or acetate salt. The compound was derived from a pineal gland extract called epithalamin, a heterogeneous preparation investigated in the former Soviet Union. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology described the tetrapeptide as a constituent fragment of that extract. Commercial material is offered as a laboratory reagent rather than as a finished pharmaceutical product.
Literature searches for this compound must account for several spelling variants. Indexing databases contain epitalon, epithalon, epithalone, and AEDG, and relevant records are scattered across Russian-language and English-language journals that do not consistently cross-cite. Early publications describe the parent extract as a mixture of many peptides, whereas later work addresses the single synthetic tetrapeptide. That shift in nomenclature complicates comparison between studies, because extract data and tetrapeptide data are sometimes cited interchangeably. A search strategy omitting the alternate spellings will return an incomplete set of references.
Reported biological findings come mainly from cell culture and rodent experiments. Those studies describe changes in telomerase catalytic subunit expression, melatonin rhythm amplitude, and antioxidant enzyme activity after peptide exposure. Human data are sparse and consist of small trials with limited blinding and inconsistent endpoints. The proposed mechanisms remain hypotheses rather than established facts, and there is no consensus on whether effects observed in animals carry over to people. Independent replication outside the original research groups is limited, which is a recognised gap in the published literature.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
== Function == In the heart, specialized cardiac muscle cells transmit electrical impulses from the atrioventricular node (AV node) to the Purkinje fibers – fascicles, also referred to as bundle branches. These start as a single fascicle of fibers at the AV node called the bundle of His that then splits into three bundle branches: the right fascicular branch, left anterior fascicular branch, and left posterior fascicular branch.
== See also == Hydrogenosomes and mitosomes – mitochondrion-related organelles (MROs) Spinoloricus cinziae – an anaerobic microbial animal with hydrogenosome-like organelles Monocercomonoides – genus of eukaryotes that lack mitochondria and MROs entirely Anaerobic digestion Microbial fuel cell Standard electrode potential (data page) Table of standard reduction potentials for half-reactions important in biochemistry Lithotrophs
This resulted in the creation of the NOD-scid mice which lacked T cells, B cells, and NK cells. This mouse model permitted for a slightly higher level of human cell reconstitution. Nevertheless, a major breakthrough in this field came with the introduction of the mutant IL-2 receptor (IL2rg) gene in the NOD-scid model. This accounted for the creation of the NOD-scid-γcnull mice (NCG, NSG or NOG) models which were found to have defective signaling of interleukins IL-2, IL-4, IL-7, IL-9, IL-15 and IL-21. Researchers evolved this NSG model by knocking out the RAG1 and RAG2 genes (recombination activation genes), resulting into the RAGnull version of the NSG model that was devoid of major cells of the immune system including the natural killer cells, B lymphocytes and T lymphocytes, macrophages and dendritic cells, causing the greatest immunodeficiency in mice models so far. The limitation with this model was that it lacked the human leukocyte antigen. In accordance to this limitation, the human T cells when engrafted in the mice, failed to recognize human antigen-presenting cells, which consequated in defective immunoglobulin class switching and improper organization of the secondary lymphoid tissue. To circumvent this limitation, the next development came with the introduction of transgenes encoding for HLA I and HLA II in the NSG RAGnull model that enabled buildout of human T-lymphocyte repertoires as well as the respective immune responses. Mice with such human genes are technically human-animal hybrids.
Sources: en.wikipedia.org
=== Molten oxide electrolysis === Molten oxide electrolysis (MOE) uses electrolysis of molten iron oxide to yield metallic iron. It is studied in laboratory-scale experiments and is proposed as a method for industrial iron production that has no direct emissions of carbon dioxide. It uses a liquid iron cathode, an anode formed from an alloy of chromium, aluminium and iron, and the electrolyte is a mixture of molten metal oxides into which iron ore is dissolved. The current keeps the electrolyte molten and reduces the iron oxide. Oxygen gas is produced in addition to liquid iron. The only carbon dioxide emissions come from any fossil fuel-generated electricity used to heat and reduce the metal.
=== Overall survival === Overall survival is based on death from any cause, not just the condition being treated, thus it picks up death from side effects of the treatment, and effects on survival after relapse.
Cask ale (or cask-conditioned beer) is unfiltered, unpasteurised beer that is conditioned by a secondary fermentation in a metal, plastic or wooden cask. It is dispensed from the cask by being either poured from a tap by gravity, or pumped up from a cellar via a beer engine (hand pump). Sometimes a cask breather is used to keep the beer fresh by allowing carbon dioxide to replace oxygen as the beer is drawn off the cask. Until 2018, the Campaign for Real Ale (CAMRA) defined real ale as beer "served without the use of extraneous carbon dioxide", which would disallow the use of a cask breather, a policy which was reversed in April 2018 to allow beer served with the use of cask breathers to meet its definition of real ale.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.