The short version of research chemical fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised and often hygroscopic |
| Solubility class | Freely soluble in water | Poor solubility in non-polar solvents |
| Typical storage temperature | -20 degrees Celsius or colder | Sealed, desiccated, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Establishes purity and confirms mass |
| Common salt form | Trifluoroacetate or acetate | Counterion reported alongside purity values |
Analytical characterization of epitalon relies on standard peptide methods. Reverse-phase high-performance liquid chromatography is used to assess purity, and mass spectrometry confirms identity by checking the observed mass against the expected value near 390 daltons. Amino acid analysis can verify composition. Because the peptide is short and hydrophilic, it elutes early on many reverse-phase columns, so method development often requires ion-pairing reagents to achieve adequate retention and resolution from related impurities.
Storage and handling follow conventional peptide practice. Lyophilized epitalon is typically kept refrigerated or frozen, protected from moisture and light, and allowed to equilibrate to room temperature before opening to avoid condensation. Once dissolved, aqueous solutions are usually stored cold and used within a short period, since dilute peptide solutions can support microbial growth and may slowly degrade. The absence of cysteine and methionine reduces, but does not eliminate, oxidation concerns during long-term storage.
Regulatory status varies by country and is not harmonized. Epitalon is not an approved drug in major Western jurisdictions. In some countries it is sold as a research chemical, and in others it has appeared in products marketed for other categories. This inconsistent status means that purity, labeling accuracy, and documentation differ widely between suppliers, and verification of identity and purity through independent analysis is the usual way buyers assess a given lot.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
Although vitamin A was not confirmed as an essential nutrient and a chemical structure described until the 20th century, written observations of conditions created by deficiency of this nutrient appeared much earlier in history. Sommer classified historical accounts related to vitamin A and/or manifestations of deficiency as follows: "ancient" accounts; 18th- to 19th-century clinical descriptions (and their purported etiologic associations); early 20th-century laboratory animal experiments, and clinical and epidemiologic observations that identified the existence of this unique nutrient and manifestations of its deficiency.
Evidence that the groups had been infiltrated by German Intelligence undercover agents has since emerged, partly through the insistence of the son of the State Counsel Siegfried Buback, who had been shot by members of the RAF in 1977.
==== MeSH D12.776.467.374.440 – interferons ==== MeSH D12.776.467.374.440.890 – interferon type i MeSH D12.776.467.374.440.890.125 – interferon type i, recombinant MeSH D12.776.467.374.440.890.125.100 – interferon alfa-2a MeSH D12.776.467.374.440.890.125.150 – interferon alfa-2b MeSH D12.776.467.374.440.890.125.200 – interferon alfa-2c MeSH D12.776.467.374.440.890.250 – interferon-alpha MeSH D12.776.467.374.440.890.250.100 – interferon alfa-2a MeSH D12.776.467.374.440.890.250.150 – interferon alfa-2b MeSH D12.776.467.374.440.890.250.200 – interferon alfa-2c MeSH D12.776.467.374.440.890.275 – interferon-beta MeSH D12.776.467.374.440.893 – interferon type ii MeSH D12.776.467.374.440.893.510 – interferon-gamma, recombinant
Sources: en.wikipedia.org
=== Pharmacodynamics (PD) === Pharmacodynamic models focus on elucidating the intricate relationship between drug concentration and its effects on the body. This includes both the desired therapeutic effects and potential side effects. By delineating the time course of drug effects, these models contribute to the prediction of efficacy and adverse events, aiding in the identification of optimal dosing strategies.
Strontium carbonate and other strontium salts are added to fireworks to give a deep red colour. This same effect identifies strontium cations in the flame test. Fireworks consume about 5% of the world's production. Strontium carbonate is used in the manufacturing of hard ferrite magnets. Strontium chloride is sometimes used in toothpastes for sensitive teeth. One popular brand includes 10% total strontium chloride hexahydrate by weight. Small amounts are used in the refining of zinc to remove small amounts of lead impurities. The metal itself has a limited use as a getter, to remove unwanted gases in vacuums by reacting with them, although barium may also be used for this purpose. The ultra-narrow optical transition between the [Kr]5s2 1S0 electronic ground state and the metastable [Kr]5s5p 3P0 excited state of 87Sr is one of the leading candidates for the future re-definition of the second in terms of an optical transition as opposed to the current definition derived from a microwave transition between different hyperfine ground states of 133Cs. Current optical atomic clocks operating on this transition already surpass the precision and accuracy of the current definition of the second.
The Pradhan Mantri Matsya Sampada Yojana (PMMSY) (http://pmmsy.dof.gov.in/) is an initiative launched by the Government of India to establish a comprehensive framework and reduce infrastructural gaps in the fisheries sector. The scheme was announced by the Finance Minister, Nirmala Sitharaman while presenting the Union budget for 2019–20 in the parliament of India on 5 July 2019. The government intends to place India in the first place in fish production and processing by implementing Neeli Kranti (transl. Blue Revolution). This scheme is in line with governments aim to double the farmers' income by 2022–23.
Benzofurans This family of compounds were identified as potential allosteric (C-terminus recognition site of peptides) inhibitor via fluorescence-based high-throughput screening in 2021. Compound 4 (Table 1) displayed high potency (ERAP1 IC50 = 34 nM) and at the same time selectivity against ERAP2 and IRAP.
Sources: en.wikipedia.org
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.
Reversed-phase HPLC establishes purity and separation from related peptides, and mass spectrometry confirms the molecular mass. Amino acid analysis can verify residue composition. No single method proves identity on its own, so the results are read together.
Yes. Residual trifluoroacetate or acetate from purification adds mass and can shift the value obtained by certain assays. Purity figures are therefore meaningful only when the counterion form is stated. Reporting both peptide content and salt form gives a clearer picture.
The peptide contains four residues in the order alanine, glutamate, aspartate and glycine, abbreviated AEDG. The chain is linear and held together by three peptide bonds. Its calculated mass for the uncharged free form is about 390.3 daltons.